Kevin Cunningham @dolearning.dev · Dec 22 So, I printed a watering can for myself but it was too big and so I decided to scale it down and print a smaller one. Looks very cute beside its big brother. Seeing a bit of stringing which I think is due to extra humidity. Need to decide if an AMS or custom solution will be best.
8 likes 2 replies
?
Replies
Worried about putting water in these at all? Both for that and food I have been hesitant. The layer lines seem like they would hinder drying / cleaning and then I worry about mold.
Honestly, having the AMS has been pretty great, but I also have the printbed enclosed as well. The humidity on their sensors is almost always at the lowest (unless I have recently swapped filament).