Caralynx @sudo.caralynx.com · Apr 14

To do so, disassemble the tool and locate the DIP switches. Push switch 2 to the on position (leaving all other switches off), then connect everything as normal and press the button. For UART, you will have to enable USB communication mode by turning switch 7 on.

0 likes 1 replies

?

Replies

Caralynx · Apr 14

The tool will show up as a CD drive. In the drive, run JLVirtualJtagSerialDevice.bat to download the driver, then install it. You will also have to set up a new virtual serial port using its serial config utility. See doc.zh-jieli.com/Tools/zh-cn/... for detailed instructions.